Pinpoint Test K : DTC U1000:00: Notes
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
Normal Operation and Fault Conditions
The DCMR uses a solid state driver (Field Effect Transistor (FET)) to control the output of several vehicle systems. When an overload occurs on any of these drivers, the DCMR disables the output and tracks the number of repetitive faults on each of these circuits. The module compares this number of overloads to 50, 000 progressive thresholds established for each circuit. At each threshold, DTC U1000:00 sets along with the DTC associated with the affected circuit. REFER to: Module Controlled Functions - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U1000:00 | Solid State Driver Protection Active: Driver Disabled: No Sub Type Information | A continuous memory DTC that sets when the BCM or DCMR has disabled a circuit due to a repetitive circuit overload and a progressive threshold is met. |
Possible Sources
- DCMR output circuit short
- DCMR