Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and locations, refer to Seat - Exploded View, Third Row .

NOTE: LH shown, RH similar.

1.

Remove the seat. For additional information, refer to Seat - Third Row .

2.

Raise the cushion, separate the cushion cover hook-and-loop strips and release the J-clips.

3.

Remove the cushion cover and foam pad from the cushion frame.

4.

NOTE: Use care when separating the cushion cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the cushion foam pad.

Separate the hook-and-loop strips and invert the cushion cover to the row of hog rings.

Courtesy of FORD MOTOR COMPANY

5.

Remove all hog rings and cushion cover.

6.

To install, reverse the removal procedure.