Removal And Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
Release the 2 backrest cover lower J-clips.
- 2.
Remove the screw and pivot bolt cover.
- Route out the attaching strap.
- 3.
Remove the 2 pin-type retainers and lower panel.
- 4.
Lower the backrest, release the cushion cover rear J-clip and route between the cushion and backrest.
- 5.
Release the hook-and-loop strip and remaining cushion cover J-clips.
- 6.
Remove the cushion foam pad and cushion cover together.
- 7.
NOTE:
Use care when separating the seat cushion cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat cushion foam.
Release the hook-and-loop strips and invert the cushion cover to the row of hog rings.
- 8.
Remove all hog rings and the cushion cover.
- 9.
To install, reverse the removal procedure.