Removal And Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
Open the roof opening panel.
- 2.
NOTE:
RH side shown, LH side similar.
Remove the 2 plastic air deflector screws.
- To install, tighten to 1 Nm (9 lb-in).
 Courtesy of FORD MOTOR COMPANY
|
- 3.
NOTE:
When the roof opening panel is removed from the tracks, inspect the tracks for any remaining guides.
Raise the front of the air deflector.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Slide the air deflector toward the rear, then lift up to release it from the pivot shafts.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
To install, reverse the removal procedure.