Pinpoint Test L : The Rear Window Washer Is Inoperative Or Always On
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- L1 CHECK THE REAR WIPER WASH SWITCH (R_WIPE_WASH_SW) PID
- Ignition ON.
- Using a diagnostic scan tool, view the SCCM PIDs.
- Using a diagnostic scan tool, monitor the SCCM R_WIPE_WASH_SW PID.
Does the PID indicate switch is activated?
Yes INSTALL a new multifunction switch. REFER to Steering Column Switches . If the concern is still present, INSTALL a new SCCM. REFER to Steering Column Switches . No GO to L2. - L2 CHECK THE WASHER PUMP RELAY
- Ignition OFF.
- Disconnect: Rear Washer Relay.
- Substitute a known good relay.
- Ignition ON.
Does the washer pump continue to operate?
Yes REMOVE the known good relay. GO to L3. No REMOVE the known good relay. INSTALL a new rear washer relay. - L3 CHECK THE REAR WASHER RELAY CONTROL CIRCUIT FOR A SHORT TO GROUND
- Ignition OFF.
- Disconnect: Windshield Wiper Motor C1656 .
Is the resistance greater than 10, 000 ohms?
Yes INSTALL a new windshield wiper motor. REFER to Wiper Motor - Windshield . No REPAIR the circuit.