Removal And Installation

Window glass assembly 

1. 1.
   
   Remove the rear striker and wiper pivot shaft assembly. For additional information, refer to Wipers and Washers .

1. 2.
   
   Disconnect the rear window defrost electrical connectors.

Courtesy of FORD MOTOR COMPANY

1. 3.
   
   
   NOTE: Do not extend the socket clips more than 2.0 mm (0.08 in) or failure of the socket can occur.
   NOTE: The liftgate glass must be supported when removing and installing the liftgate assist cylinders.

   Disconnect the 2 liftgate glass assist cylinders.

   1. 1.
      
      Insert a screwdriver blade under the socket clip and lift.

   1. 2.
      
      Gently pull the socket off the ball stud.

Courtesy of FORD MOTOR COMPANY

Window glass assembly or hinge assembly 

1. 4.
   
   Remove the liftgate glass hinge-to-body fasteners and remove the glass.
   • To install, tighten to 12 Nm (106 lb-in).

Courtesy of FORD MOTOR COMPANY

Window hinge assembly 

1. 5.
   
   Remove the liftgate glass to hinge fasteners and remove the glass.
   • Apply threadlock to the liftgate glass-to-hinge fasteners during installation.
   • To install, tighten to 8 Nm (71 lb-in).

Courtesy of FORD MOTOR COMPANY

Window glass assembly or window hinge assembly 

1. 6.
   
   To install, reverse the removal procedure.
   • Check the liftgate glass for high effort when closing. If high effort is present, adjust the striker one-half turn outboard. If high effort is still present, adjust the striker an additional one-half turn outboard. Do not exceed one full turn.