LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Focus Electric >> Repair and Diagnosis >> External Pages >> Different car >> Section 404 (Fuel System - General Information - 1.6L DURATEC-16V Ti-VCT (88KW/120PS) - Sigma) >> General Procedures >> Fuel System Pressure Release

Fuel System Pressure Release

WARNING: This page is about a different car, the 2018 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Pressure release 

  1. NOTE: The fuel pump relay fuse is located in the BJB, location F11.

    Remove the fuel pump relay fuse.

  2. Start the engine and allow it to idle until the engine stalls.
  3. Crank the engine an additional 20 seconds to make sure the fuel system pressure has been released.
  4. Turn the ignition switch to the off position.
  5. When the fuel system service is complete, install the fuel pump relay fuse.
  6. NOTE: It may take more than one key cycle to pressurize the fuel system

    Cycle the ignition key and wait 3 seconds to pressurize the fuel system. Check for leaks before starting the engine.

scientia non olet · About LEMON Manuals