Pinpoint Test A : The Rear Video Is Inoperative: Notes
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B12BD:49 | Rear Camera: Internal Electrical Failure | A continuous memory DTC that sets in the BCM when an internal fault in the rear parking aid camera is detected. |
APIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous memory and on-demand DTC that sets in the APIM if no video signal is detected from the rear parking aid camera when the vehicle is in REVERSE. |
Possible Causes
- Wiring, terminals or connectors
- Dirty rear parking aid camera lens
- Fuse
- Communication network concern
- Rear parking aid camera configuration
- Rear parking aid camera
- Reversing lamp concern
- LIN concern
- IPC concern
- APIM concern
- FDIM concern
- BCM
Visual Inspection and Diagnostic Pre-Checks
- RJB Fuse 29 (5A).
- Verify the luggage compartment lid is fully closed.
- If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Verify the rear parking aid camera configuration using the diagnostic scan tool.
NOTE:
Before disconnecting the rear parking aid camera, verify the connector is properly seated and latched.