LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Fiesta Titanium, 4D Hatchback, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Electronic Engine Controls - 1.6L ECOBOOST (132KW/180PS) - Sigma) >> Removal And Installation >> Intake Air Temperature (IAT) Sensor >> Removal

Intake Air Temperature (IAT) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the electrical connector, remove the retainers and the IAT sensor.

    Torque: 44 lb.in (5 Nm)

GFD301067Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals