Engine Cooling System Draining, Vacuum Filling and Bleeding: Draining
WARNING: This page is about a different variant/trim than selected.
- WARNING: When releasing the cooling system pressure, cover the coolant expansion tank cap with a thick cloth.
Release the cooling system pressure by slowly turning the coolant expansion tank cap between 2 and 3 turns.
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- WARNING: Be prepared to collect escaping fluid.
Release the clamp and disconnect the lower radiator hose. Use the General Equipment: Fluid Container. Use the General Equipment: Hose Clamp Remover/Installer
- Connect the lower radiator hose and install the hose clamp. Use the General Equipment: Hose Clamp Remover/Installer