Removal And Installation: Flywheel: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the flywheel and the bolts finger-tight.
- Install Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
- Tighten the flywheel bolts in sequence shown.
Torque: Stage 1: 133 lb.in (15 Nm) Stage 2: 18 lb.ft (25 Nm) Stage 3: 22 lb.ft (30 Nm) Stage 4: 90°
- Remove Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
- Install the clutch disc and pressure plate. Refer to: Clutch Disc and Pressure Plate .
- After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.