Brake Master Cylinder: Removal

For information on Ford Color Coded Illustrations refer to OEM Color Coding

1. If equipped, disconnect the front drive axle vent retainer.

   Courtesy of FORD MOTOR COMPANY

2. Disconnect the brake fluid level sensor electrical connector.

   Courtesy of FORD MOTOR COMPANY

3. Disconnect the 2 brake tube fittings.
   1. Disconnect the primary brake tube fitting.

      Torque: 22 lb.ft (30 Nm)

   2. Disconnect the secondary brake tube fitting.

      Torque: 17 lb.ft (23 Nm)

   Courtesy of FORD MOTOR COMPANY

4. Remove the 2 nuts and the brake master cylinder.

   Torque: 18 lb.ft (25 Nm)

Courtesy of FORD MOTOR COMPANY