DTC Chart: Body Control Module (BCM)
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these practices, REFER to: Diagnostic Methods .
BCM DTC Chart
| DTC | Description | Action |
|---|---|---|
| B1249:12 | Start Button Illumination: Circuit Short To Battery | GO to Pinpoint Test E |
| B1249:14 | Start Button Illumination: Circuit Short To Ground or Open | GO to Pinpoint Test E |
| U1000:00 | Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information | The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When this DTC is stored in the BCM, the illumination output driver is disabled until the cause of the excessive current draw has been corrected and a successful self-test has been performed. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern has been corrected, CLEAR the DTC and PERFORM the BCM self-test. |
| U2010:11 | Switch Illumination: Circuit Short to Ground | GO to Pinpoint Test B |
| U2010:15 | Switch Illumination: Circuit Short to Battery or Open | If one or more non-networked illumination source is inoperative, GO to Pinpoint Test B If one or more non-networked illumination source is always on, GO to Pinpoint Test H |
| All other DTCs | - | REFER to: Body Control Module (BCM) . |