LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Escape S >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BG : The Turn/Hazard Signal On Warning Chime Is Inoperative >> Pinpoint Test BG : The Turn/Hazard Signal On Warning Chime Is Inoperative

Pinpoint Test BG : The Turn/Hazard Signal On Warning Chime Is Inoperative

  1. BG1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver safety belt.

    • Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BG2
    No  Refer to IPC HARDWARE TESTING .

  2. BG2 CHECK THE TURN SIGNAL INDICATOR OPERATION

    • Place the turn signal in the LH or RH turn position and monitor the turn indicator operation.

    Do the turn indicators operate correctly? 

    Yes  GO to  BG3
    No  GO to Pinpoint Test V 

  3. BG3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Body Control Module (BCM) .
    No  Refer to IPC HARDWARE TESTING .
scientia non olet · About LEMON Manuals