LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Edge SE, AWD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> ENGINE CONTROLS - FUEL CHARGING AND CONTROLS - TURBOCHARGER - 2.0L ECOBOOST (184kW/250PS) - MI4 >> Removal And Installation >> Wastegate Vacuum Sensor >> Installation

Wastegate Vacuum Sensor: Installation

  1. Install the wastegate pressure sensor, then install and tighten the wastegate pressure sensor retainer.

    Torque: 53 lb.in (6 Nm)

    GFD280018Courtesy of FORD MOTOR COMPANY
  2. Connect the wastegate pressure sensor hose and the wastegate pressure sensor electrical connector. Use the General Equipment: Hose Clamp Remover/Installer
    GFD280017Courtesy of FORD MOTOR COMPANY
  3. Install the underbody shield and the retainers.
GFD280016Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals