Wastegate Control Valve Solenoid: Removal

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
2. Remove the Powertrain Control Module (PCM). Refer to: Powertrain Control Module (PCM) .
3. Remove retainers and the underbody shield.

   Courtesy of FORD MOTOR COMPANY

4. Disconnect the wastegate control valve solenoid hoses and the wastegate control valve solenoid electrical connector. Use the General Equipment: Hose Clamp Remover/Installer

   Courtesy of FORD MOTOR COMPANY

5. Remove the wastegate control valve solenoid retainers and then remove the wastegate control valve solenoid.

Courtesy of FORD MOTOR COMPANY