| A module does not communicate with the diagnostic scan tool |
REFER to: Communications Network
. |
| The audible parking aid is inoperative |
GO to Pinpoint Test A |
| Continuous or intermittent tone when no obstacles or fault codes are present |
CLEAN the rear bumper and sensors with high-pressure water. |
| ALLOW time for the ice between the parking aid sensor(s) and bezel(s) to melt. |
| INSTALL the parking aid sensor(s) into the parking aid sensor bezel(s) correctly. For the rear sensors, For the front sensors, |
| CARRY OUT the elevation system check. REFER to: Elevation System Check . |
| INSTALL a new parking aid sensor. For the rear sensors, For the front sensors, |
| The parking aid audio tones are inoperative |
GO to Pinpoint Test A |
| The Parking Aid Switch Status LED Is Inoperative Or Always On |
GO to Pinpoint Test J |
| The parking aid disable switch is inoperative or does not operate correctly |
GO to Pinpoint Test K |
| The parking aid menu is not available in the message center and cannot be deactivated |
The parking aid disable feature is not available when a MyKey® restricted key is in use. This is normal operation. |