Removal And Installation: Flexplate: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
- Install the flexplate and the new bolts. Tighten in the sequence shown in illustration in 3 stages.
Torque:
Stage 1: 18 lb.ft (25 Nm)
Stage 2: 33 lb.ft (45 Nm)
Stage 3: 45°
- Remove Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
- Install the flexplate and the new bolts. Tighten in the sequence shown in illustration in 3 stages.
- 2.
Install the transmission. Refer to: Transmission - 3.2L Duratorq-TDCi (148kW/200PS) - Puma .