Crankshaft Position (CKP) Sensor: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
Rotate the crankshaft until the trigger tooth is visible through the CKP sensor housing.
 Courtesy of FORD MOTOR COMPANY
|
- 2.
- Install the CKP sensor and loosely install the bolt. Apply light pressure to ensure contact with the 0.02 inch (0.5 mm) feeler gauge blade. Use the General Equipment: Feeler Gauge
- Tighten the bolt
Torque: 71 lb.in (8 Nm)
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Connect the CKP sensor electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Install the heat shield and the bolt.Torque: 21 lb.ft (28 Nm)
 Courtesy of FORD MOTOR COMPANY
|