Pinpoint Test C : B10E5:11: Notes
WARNING: This page is about a different variant/trim than selected.
Normal Operation and Fault Conditions
The wake-up control circuit wakes up the PCM prior to engine cranking to allow it time to initialize. The wake-up control circuit is activated by the BCM when the driver door is opened, a key is inserted into the ignition, or when the ignition is in the ON or START position.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B10E5:11 | PCM Wake-up Signal: Circuit Short to Ground | This DTC sets in the BCM when a short to ground is detected on the wake-up control circuit. |
Possible Sources
- BCM
- PCM
- Wiring, terminals or connectors