Transport and Factory Mode Deactivation

Deactivation

NOTE: During vehicle build, some vehicle modules are set in factory mode including the IPC and the BCM. When the vehicle build is complete, the vehicle is set to transport mode. Transport mode reduces the drain on the battery during longer periods where the vehicle is not used. Various systems may be altered or are disabled when in the transport mode. The vehicle automatically reverts to normal operation mode after being driven 80 km (50 mi).

1.

WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

Place the ignition in the OFF position.

2.

Verify the battery is fully charged. Refer to: Battery .

3.

Place the ignition in the ON position.

4.

NOTE: Steps 4 and 5 must be carried out within 10 seconds.

Press and release the brake pedal 5 times.

5.

NOTE: Pressing the hazard switch twice without pressing the brake pedal 5 times will cause the factory or transport mode to be paused for 10 minutes.

Press and release the hazard switch 2 times (on, off).

6.

NOTE: When exiting factory mode, the IPC message center indicates TRANSPORT MODE when the procedure has been successfully completed (not applicable to vehicles equipped with low level message center display).

NOTE: When exiting transport mode, the IPC message center indicates NORMAL MODE when the procedure has been successfully completed (not applicable to vehicles equipped with low level message center display).

NOTE: Check vehicle again after 10 minutes for message center indications that confirm factory mode or transport mode is deactivated. If factory/transport mode is still enabled after 10 minutes, perform this procedure again.

Place the ignition in the OFF position.