Beam Axle: Installation

Install the beam axle and the bolts.
Torque: 129 lb.ft (175 Nm)

Courtesy of FORD MOTOR COMPANY
NOTE: Only tighten the nut and bolt finger tight at this stage.

On both sides. Install rear shock absorber lower bolts.

Courtesy of FORD MOTOR COMPANY
On both sides. Position the axle stand supporting the beam axle. Lower the floor jack maintaining 5mm gap between vehicle and jack.

Courtesy of FORD MOTOR COMPANY
On both sides. Tighten rear shock absorber lower bolts.
Torque: 85 lb.ft (115 Nm)

Courtesy of FORD MOTOR COMPANY
To install, reverse the removal procedure.