P0369 - Camshaft Position Sensor B Circuit Intermittent (Bank 1)

P0369 - CAMSHAFT POSITION SENSOR B CIRCUIT INTERMITTENT (BANK 1)

Description:	This DTC sets when the CMP11 (6.2L) or CMP12 (all others) circuit signal is intermittent. For additional camshaft position (CMP) sensor location information, refer to ENGINE CONTROL COMPONENTS .
Possible Causes:	Intermittent open circuit Intermittent short circuit Camshaft timing incorrectly set Camshaft position sensor trigger wheel out of alignment Damaged camshaft position bank 1 sensor 1 (CMP11) shielding (6.2L) Damaged camshaft position bank 1 sensor 2 (CMP12) shielding (all others) Incorrect harness connections Corrosion Damaged mechanical vacuum pump (Expedition, F-150, Navigator, Transit) Damaged CMP11 sensor (6.2L) Damaged CMP12 sensor (all others)
Diagnostic Aids:	Harness routing, harness alterations, incorrect shielding, or electrical interference from other systems may have an intermittent impact on the CMP signal. For Expedition, F-150, Navigator and Transit, check for a camshaft position sensor trigger wheel alignment concern and a damaged mechanical vacuum pump. Make sure the mechanical vacuum pump oil feed hole is not restricted. Repair as necessary.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to Pinpoint Test DR .