Oil Pump: Installation

Prime the oil pump. Add 2 tablespoons of clean engine oil to the oil pump and rotate the oil pump by hand.
To install, reverse the removal procedure.
NOTE: Clean the oil pump and cylinder block mating surfaces with Motorcraft ® Metal Surface Prep.

Install the oil pump and the bolts. Tighten in sequence shown in 2 stages.

Material: Motorcraft ® Metal Surface Prep Wipes / ZC-31-B

Torque:

Stage 1: 89 lb.in (10 Nm)

Stage 2: 177 lb.in (20 Nm)

Fig 1: Oil Pump Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Install a new oil pickup tube O-ring.

Courtesy of FORD MOTOR COMPANY
Clean all mating surfaces.
Material: Motorcraft ® Silicone Gasket Remover / ZC-30-A

Material: Motorcraft ® Metal Surface Prep Wipes / ZC-31-B
NOTE: The component must be installed within 10 minutes of applying the sealant.

Apply a bead of silicone sealant.

Material: Motorcraft ® Silicone Gasket and Sealant / TA-30 (WSE-M4G323-A4)

Courtesy of FORD MOTOR COMPANY
NOTE: Only tighten the bolts finger tight at this stage.

Install the oil pan and the bolts.

Courtesy of FORD MOTOR COMPANY
Align the oil pan to the cylinder block. Use the General Equipment: Round-Ended Steel Rule

Courtesy of FORD MOTOR COMPANY
Tighten the oil pan bolts in sequence shown.
Torque: 177 lb.in (20 Nm)

Courtesy of FORD MOTOR COMPANY
Tighten the oil filter three-fourths turn after the oil filter gasket makes contact with the oil filter adapter.
Material: Motorcraft ® SAE 5W-20 Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)

Courtesy of FORD MOTOR COMPANY
Fill the engine with clean engine oil.
Material: Motorcraft ® SAE 5W-20 Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)