DTC Chart: Body Control Module (BCM)

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these practices, REFER to: Diagnostic Methods .

DTC	Description	Action
U1000:00	Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information	The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When this DTC is stored in the BCM, the output driver is disabled until the cause of the excessive current draw has been corrected and a successful self-test has been carried out. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern has been corrected, CLEAR the DTC and CARRY OUT the BCM self-test.
U2010:11	Switch Illumination: Circuit Short to Ground	GO to Pinpoint Test A
U2010:15	Switch Illumination: Circuit Short to Battery or Open	If the non-networked dimmable illumination sources are inoperative, GO to Pinpoint Test A If the non-networked dimmable illumination sources are always on, GO to Pinpoint Test B
U3000:49	Control Module: Internal Electronic Failure	The BCM has permanently disabled an output because an excessive current draw exists (such as a short to ground) that has exceeded the limits of what the BCM can withstand. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern has been corrected, Refer to: BCM Hardware Testing .
All other BCM Diagnostic Trouble Codes (DTCs)	-	REFER to: Body Control Module (BCM) .