LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Transit Connect XLT, Van Passenger >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumper System >> Removal And Installation >> Front Bumper Cover >> Removal

Front Bumper Cover: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. Remove the headlamp assembly. Refer to: Headlamp Assembly .
  3. Disconnect the hood safety latch cable and position aside.
    GFD216734Courtesy of FORD MOTOR COMPANY
  4. Remove the screws.
    GFD216735Courtesy of FORD MOTOR COMPANY
  5. On both sides. Remove the push pins and position the fender liner aside.
    GFD216736Courtesy of FORD MOTOR COMPANY
  6. Remove the radiator deflector screws. Use the General Equipment: Interior Trim Remover
    GFD216737Courtesy of FORD MOTOR COMPANY
  7. Release the tabs and separate the outer edges of the front bumper cover assembly.
    GFD216738Courtesy of FORD MOTOR COMPANY
  8. Remove the front bumper cover.

    1. Release the tabs.
    2. If equipped. Disconnect the electrical connectors.

GFD216739Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals