LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Transit Connect XLT, Van Passenger >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumper System >> Disassembly And Assembly >> Front Bumper Cover >> Disassembly

Front Bumper Cover: Disassembly

  1. Remove the front bumper cover. Refer to: Front Bumper Cover .
  2. If equipped.

    1. Disconnect the front fog lamp electrical connectors.
    2. Disconnect the front parking aid electrical connectors.
    3. Detach the retainers and remove the electrical wire harness.

    GFD216754Courtesy of FORD MOTOR COMPANY

    Vehicles with front parking aid 

  3. NOTE: Pressure must not be applied to the outer face of the parking aid sensor.

    Release the tabs and remove the front parking aid sensor from the bracket.

    GFD216755Courtesy of FORD MOTOR COMPANY

    All vehicles 

  4. Remove the retainers and the hood seal.
    GFD216756Courtesy of FORD MOTOR COMPANY
  5. Remove the push pins. Use the General Equipment: Interior Trim Remover
    GFD216757Courtesy of FORD MOTOR COMPANY
  6. Release the tabs and remove the bumper reinforcement.
    GFD216758Courtesy of FORD MOTOR COMPANY
  7. Release the tabs, remove the tow hook cover, remove the upper radiator grille and the lower radiator grille.
    GFD216759Courtesy of FORD MOTOR COMPANY
  8. Release the tabs and remove the front bumper cover upper trim.
    GFD216760Courtesy of FORD MOTOR COMPANY
  9. Release the tabs and remove the lower bumper cover.
    GFD216761Courtesy of FORD MOTOR COMPANY

    Vehicles with front fog lamps 

  10. Remove the screws and the front fog lamps.
    GFD216762Courtesy of FORD MOTOR COMPANY
  11. Cut the sealing and remove the front fog lamp mounting assembly. Use the General Equipment: Knife
GFD216763Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals