DTC Chart: Body Control Module (BCM)
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
BCM DTC Chart
| DTC | Description | Action |
|---|---|---|
| B1087:86 | LIN Bus "A": Signal Invalid | If the low beams and the windshield wipers are both on, GO to Pinpoint Test C If only the low beams are on, GO to Pinpoint Test C If only the windshield wipers are on, REFER to: Wipers and Washers . |
| B1130:07 | Light Switch Module: Mechanical Failure | INSTALL a new headlamp switch. Refer to: Headlamp Switch . |
| B1130:83 | Light Switch Module: Value of Signal Protection Calculation Incorrect | GO to Pinpoint Test C |
| B1130:87 | Light Switch Module: Missing message | GO to Pinpoint Test C |
| B1D00:11 | Left Low Beam: Circuit Short to Ground | GO to Pinpoint Test A |
| B1D00:15 | Left Low Beam: Circuit Short to Battery or Open | If the low beam is inoperative, GO to Pinpoint Test A If the low beam is always on, GO to Pinpoint Test C |
| B1D01:11 | Right Low Beam: Circuit Short to Ground | GO to Pinpoint Test A |
| B1D01:15 | Right Low Beam: Circuit Short to Battery or Open | If the low beam is inoperative, GO to Pinpoint Test A If the low beam is always on, GO to Pinpoint Test C |