BCM DTC Chart
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B12BD:01 | Rear Camera: General Electrical Failure | GO to Pinpoint Test A |
| B12BD:02 | Rear Camera: General Signal Failure | GO to Pinpoint Test A |
| B12BD:49 | Rear Camera: Internal Electronic Failure | Sets in continuous memory and on-demand in the BCM when an internal fault is detected in the rear parking aid camera. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the BCM self-test. If DTC B12BD:49 returns, INSTALL a new rear parking aid camera. Refer to: Rear Parking Aid Camera . |
| B12BD:55 | Rear Camera: Not Configured | Sets in continuous memory and on-demand in the BCM when the front parking aid camera is not configured. VERIFY the battery voltage and condition. CONFIGURE the camera using a diagnostic scan tool under Electrical>Service Functions>LIN New Module Initialization |
| B12BD:83 | Rear Camera: Value of Signal Protection Calculation Incorrect | GO to Pinpoint Test E |
| B12BD:86 | Rear Camera: Signal Invalid | GO to Pinpoint Test E |
| U0264:87 | Lost Communication With Camera Module - Rear: Missing Message | GO to Pinpoint Test E |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module (BCM) . |