Pinpoint Test C : DTCS P0760, P0763, P0764, P0979, P0980: Notes
Refer to Transmission Controls - MPS6 for schematic and connector information.
Normal Operation and Fault Conditions
The PCM applies and releases the various clutches in the transmission by actuating the shift solenoids in the solenoid body. SSC is a Variable Force Solenoid (VFS).
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0760 | SSC | Open circuit in the solenoid or wire harness. |
| P0763 | SSC Electrical | Open circuit in the solenoid or wire harness. |
| P0764 | SSC Intermittent | Intermittent circuit in the solenoid or wire harness open, shorted to ground or shorted to power. |
| P0979 | SSC Control Circuit Low | Short to ground in the solenoid or wire harness. |
| P0980 | SSC Control Circuit High | Open circuit or short to power in the solenoid or wire harness. |
Possible Sources
- Connectors damaged or pushed-out terminals, corrosion, loose wires and missing or damaged seals
- SSC
- Transmission internal wiring harness frame
- PCM