P0463 - Fuel Level Sensor A Circuit High
P0463 - FUEL LEVEL SENSOR A CIRCUIT HIGH
| Description: | This DTC sets when the FLI signal is greater than the maximum allowable calibrated parameter for a specified fuel fill percentage in the fuel tank. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the FLI PIDs in ignition ON, engine running. A concern is present if the FLI percentage PID is at 25% fill and the FLI voltage PID is less than 0.90 volt with a non-matching fuel gauge or the FLI percentage PID is at 75% fill and the FLI voltage PID is greater than 2.45 volts with a non-matching fuel gauge. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test HX . | ||