LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Transit Connect XL, Van Cargo >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.5L DURATEC (125KW/170PS) >> Removal And Installation >> Engine Mount >> Removal

Engine Mount: Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. If equipped.

    1. Remove the retainers and the underbody shield reinforcement.
    2. Remove the retainers and the underbody shield.

    GFD214403Courtesy of FORD MOTOR COMPANY
  3. Using a floor jack and wooden block, support the engine. Use the General Equipment: Trolley Jack Use the General Equipment: Wooden Block
    GFD214550Courtesy of FORD MOTOR COMPANY
  4. Release the degas bottle support tabs, disconnect the coolant hose routing clip and position the degas bottle aside.
    GFD214564Courtesy of FORD MOTOR COMPANY
    1. Remove the engine mount nuts.
    2. Remove the bolts and the engine mount.
GFD214565Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals