Networked Input Messages and Default States

NOTE: Whenever a network message is suspected as missing and confirmed by a missing message DTC (U-code), it is important to look for other symptoms that can also be present in the IPC and throughout the vehicle. Once a DTC sets in the IPC, it can be helpful to review the complete message list to determine which other modules also rely on the same message and run the self-test for those modules. If the message is missing from other modules, the same DTC can also be set in those modules. Confirmation of missing messages common to multiple modules can indicate that the originating module is the source of the concern or the communication network may be faulted.

The IPC uses input messages from other modules to control the gauges, informational indicators, warning indicators and message center message displays over the communication networks. The majority of messaged inputs to the IPC are received from the BCM. When a network message is required by the IPC from a module on the HS-CAN, the BCM acts as a gateway to convert the message and sends it to the IPC over the MS-CAN. Network messages can drop out or be missing for a variety of reasons, such as high network traffic on the bus. The IPC incorporates a defined strategy for handling missing network messages based on time. The required time for a network message to be missing differs between the various gauges, indicators and message center displays. The strategy is basically the same for all indication but differs in the length of time required for the network message to be missing. If a required network message is missing or invalid for less than the preset time criteria, the gauge, indicator or message center display that requires the network message remains at the last commanded state based upon the last network message received.

For example, if the stability/traction control network message is missing for less than 5 seconds and the stability/traction control indicator (sliding car icon) was on, the indicator remains in the on state until the next network message is received. If the network message remains missing or invalid for more than 5 seconds, the IPC sets a U-code DTC and the IPC output becomes a default action for the indicator or gauge. The indicator may default on/off or the gauge may default to the rest position.

Each indicator or gauge utilizes a different default strategy depending on the nature of the indication. Refer to the diagnostic overview descriptions located before each individual pinpoint test for further description of the default action specific to each indicator or gauge. If the missing messaged input to the IPC returns at any time, the normal function of the gauge, indicator or message center display resumes.

It is very important to understand:

where the input originates.
all the information necessary in order for a feature to operate.
which module(s) receive(s) the input or command message.
which module controls the output of the feature.
whether the module that receives the input controls the output of the feature, or whether it outputs a message over the communication network to another module.