LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Transit Connect Titanium >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BD : U3006:17 >> Pinpoint Test BD : U3006:17

Pinpoint Test BD : U3006:17

  1. BD1 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) B1317, B1676, P0563 (PCM (POWERTRAIN CONTROL MODULE)) U3003:17 OR U3006:17 SET IN OTHER MODULES

    • Ignition ON.

    • Using a diagnostic scan tool, perform the self-test.

    • Retrieve the continuous memory Diagnostic Trouble Codes (DTCs) from all modules.

    Is DTC B1317, B1676, P0563 (PCM or U3006:17 set in more than one module? 

    Yes  DIAGNOSE the overcharging condition. Refer to: Charging System - 2.5L Duratec (125kW/170PS) .
    No  GO to  BD2

  2. BD2 CHECK THE BATTERY VOLTAGE

    • Turn off all interior/exterior lights and accessories.

    • Start and run the engine at approximately 2, 000 rpm for 3 minutes while monitoring the battery voltage.

    Does the battery voltage rise to 15.5 volts or higher? 

    Yes  DIAGNOSE the overcharging condition. Refer to: Charging System - 2.5L Duratec (125kW/170PS) .
    No  GO to  BD3

  3. BD3 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U3006:17

    • Turn the engine off.

    • Ignition ON.

    • Using a diagnostic scan tool, clear the continuous memory Diagnostic Trouble Codes (DTCs).

    • Carry out the IPC self-test.

    Is DTC U3006:17 present? 

    Yes  Refer to IPC Hardware Testing .
    No  The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals