LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Fusion Titanium, FWD >> Repair and Diagnosis >> Brakes >> Parking Brake System - Parking Brake Actuation (Except Hybrid) >> Description And Operation >> Parking Brake - System Operation and Component Description >> System Operation >> Network Message Chart

Network Message Chart

NOTE: The TCM is also known as the Secondary On Board Diagnostic Module C (SOBDMC).

Module Network Input Messages - ABS Module 

Broadcast Message Originating Module Message Purpose
Accelerator pedal position PCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module of the current position of the accelerator pedal, 0-100%.
Brake on-off switch PCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module the driver has pressed the brake pedal.
Clutch pedal position PCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module the driver has pressed the clutch pedal.
Driven wheel propulsion torque PCM This message is sent to the GWM and then to the ABS module. This message provides the ABS module of the current amount of propelling torque being applied to the driven wheels by the engine or electric motor.
Driver door ajar status BCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module the driver door status, closed or open.
Driver seat belt buckle status RCM This message informs the ABS module of the current status of the driver seat belt buckle; buckled, unbuckled, faulty or unknown.
Engine off time PCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module how long, in seconds, the engine has been off.
Engine Revolutions Per Minute (RPM) PCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module of the current engine Revolutions Per Minute (RPM).
Gear lever position TCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module of the current gear selector lever position.
Ignition status BCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module of the current ignition status; off, accessory, run, start, invalid or unknown.
Key in ignition status BCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module of the current ignition key status; in or out.
Longitudinal acceleration RCM The ABS module uses this message to confirm forward or rearward vehicle movement.
Transmission in REVERSE PCM This message is sent to the GWM and then to the ABS module. This message informs the ABS module of the current reverse gear status; inactive or active.
Vehicle configuration data BCM This message is sent to the GWM and then to the ABS module. This message provides the ABS module with the current optional and configured items such as tire size, axle ratio, manual or automatic transaxle, keyless entry and VIN.
scientia non olet · About LEMON Manuals