LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes (Hybrid/ENERGI) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes - 2.0L Duratec - Hybrid (96kW/130PS) >> Pinpoint Tests >> Pinpoint Test Be : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative >> Pinpoint Test Be : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative

Pinpoint Test Be : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative

  1. BE1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver safety belt.

    • Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BE2
    No  Refer to: IPC Hardware Testing .

  2. BE2 CHECK THE TURN SIGNAL INDICATOR OPERATION

    • Verify the RH and LH turn signal indicators operate correctly.

    Do the turn signal indicators operate correctly? 

    Yes  GO to  BE3
    No  GO to Pinpoint Test L 

  3. BE3 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Multifunction Electronic Modules (Hybrid/Energi) .
    No  Refer to: IPC Hardware Testing .
scientia non olet · About LEMON Manuals