Turbocharger Oil Supply Tube RH: Installation
- Install the new turbocharger oil supply tube O-ring seals and the new turbocharger oil supply tube oil filter. Lubricate the O-ring seals with clean engine oil. Refer to: Specifications
.
-
NOTE: Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore and the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. DO-NOT USE A METAL BRUSH; DAMAGE TO SEALING AREA WILL RESULT IN LEAKS.NOTE: When installing the turbocharger oil supply tube into the engine block, use care not to damage the new turbocharger oil supply tube oil filter.
Install the turbocharger oil supply tube, then install and tighten the turbocharger oil supply tube bolts.
Material: Motorcraft ® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
Torque: 89 lb.in (10 Nm)
- Install the turbocharger heat shield, then install and tighten the heat shield retainers.
Torque: 89 lb.in (10 Nm)
- Install the Engine Oil Pressure (EOP) Sensor. Refer to: Engine Oil Pressure (EOP) Sensor .
- Install the underbody shield and then install the underbody shield retainers.
- Check and top off the engine oil as needed. Refer to: Specifications .