Parking Brake Control - RS: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Remove the floor console. Refer to: Floor Console - Vehicles With: Center Armrest . Refer to: Floor Console - Vehicles Without: Center Armrest .
- 3.
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- 8.
Detach the front parking brake cable from the equalizer and detach the rear parking brake cables from the body.
- 9.NOTE: During installation, make sure the cable seal is fully seated.
Remove the parking brake control.
- 1.
Disconnect the parking brake switch electrical connector
- 2.
Remove the bolts.Torque: 26 lb.ft (35 Nm)
- 3.
Detach the cable seal and remove the parking brake control.
- 1.