Transport and Factory Mode Deactivation

Deactivation

WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.

1.

Refer to: Health and Safety Precautions

2.

Place the ignition in the OFF position.

3.

Verify the battery is fully charged. REFER to: Battery

4.

NOTE: On vehicles with Push-Button Start, place a programmed passive key in the PATS backup starting location.

Place the ignition in the ON position.

5.

NOTE: Steps 5 and 6 must be carried out within 10 seconds.

Press and release the brake pedal 5 times.

6.

Press and release the hazard switch 2 times (on, off).

7.

NOTE: When exiting Factory mode, the IPC message center will indicate NORMAL MODE when the procedure has been successfully completed.

Place the ignition in the OFF position.