Brake Fluid Reservoir: Removal
NOTE:
Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Refer to: Brake Master Cylinder .
- 3.NOTE: Install new brake fluid reservoir seals. Lubricate the seals with clean, specified brake fluid.
Material: Motorcraft ® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2)