Halfshaft Seal RH: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
Using the special tool install the halfshaft seal. Use Special Service Tool: 308-880 Installer, Driveshaft Seal.
- 2.NOTE: Do not fully install the shaft at this time.
- Using part: AA5P-4N206-A.
- Remove the special tool before completely installing the halfshaft.
- 3.NOTE: Insert the intermediate shaft until the intermediate shaft bearing is centered in the concave groove of the intermediate shaft bearing bracket.
Install the RH halfshaft.
- 4.
Tighten:Install the new half shaft bearing strap and nuts.Torque:
Stage 1: Lower nut:: 44 lb.in (5 Nm)
Stage 2: Upper nut:: 18 lb.ft (25 Nm)
Stage 3: Lower nut:: 18 lb.ft (25 Nm)
- 5.
Install the balljoint protector clip. Position the ball joint into the wheel knuckle and install the new balljoint bolt and nut.Torque: 38 lb.ft (52 Nm)
- 7.
Check the transmission fluid level. Refer to: Transmission Fluid Level Check .
- 9.
Install the wheel and tire. Refer to: Wheel and Tire .