LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Fiesta Titanium, 4D Hatchback, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Cooling System - 1.6L ECOBOOST (132KW/180PS) - Sigma) >> Removal And Installation >> Thermostat >> Removal

Removal And Installation: Thermostat: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .

  1. 2.

    Remove the generator. Refer to: Generator - 1.6L EcoBoost (132kW/180PS) - Sigma .

  1. 3.

    Disconnect the coolant shutoff solenoid valve electrical connector, detach the retainer and position the wiring harness aside.
GFD139772Courtesy of FORD MOTOR COMPANY

  1. 4.

    GFD139658Courtesy of FORD MOTOR COMPANY
    GFD139659Courtesy of FORD MOTOR COMPANY

    1. 1.

      Release the clip.

    1. 2.

      Disconnect the coolant outlet hose.
    • Release the clamp and disconnect the radiator hose.
GFD139785Courtesy of FORD MOTOR COMPANY

  1. 5.

    Remove the bolts and the coolant shutoff solenoid valve.

    Torque: 89 lb.in (10 Nm)

GFD139786Courtesy of FORD MOTOR COMPANY

  1. 6.

    Release the clamp and disconnect coolant bypass hose. Use the General Equipment: Hose Clamp Remover/Installer
GFD139787Courtesy of FORD MOTOR COMPANY

  1. 7.

    Remove the bolts and the thermostat housing.

    Torque: 89 lb.in (10 Nm)

GFD139788Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals