Coolant Pump: Installation

Install the coolant pump and tighten the bolts in the sequence order.

Torque: 89 lb.in (10 Nm)

1. 1.
   
   Install the timing belt tensioner and tighten the bolt.

   Torque: 18 lb.ft (25 Nm)

1. 2.
   
   Remove the holding pin.

1. 1.
   
   
   NOTE: Make sure that the components are installed to the position noted before removal.

1. 2.
   
   Remove Special Service Tool: 303-1556 Locking Tool, Timing Belt.

1. 1.
   
   Install the timing cover and tighten the bolts.

   Torque: 89 lb.in (10 Nm)

1. 2.
   
   Finger tight. Install the engine mount stud.

1. 3.
   
   Finger tight. Install the coolant pump pulley and the bolts.

1. 4.
   
   Install and tighten the wiring harness bracket bolt.

   Torque: 71 lb.in (8 Nm)

1. 5.
   
   Attach the wiring harness retainer.

1. 6.
   
   Attach the wiring harness retainer.

1. 1.
   
   Close the cover.

1. 2.
   
   Install and tighten the timing cover stud bolt.

   Torque: 89 lb.in (10 Nm)

Torque: 35 lb.ft (48 Nm)

Torque: 71 lb.in (8 Nm)

Torque: 177 lb.in (20 Nm)

1. 1.
   
   Position the support bracket and tighten the bolts.

   Torque: 35 lb.ft (48 Nm)

1. 2.
   
   Install the axle bearing support and tighten the nuts.

   Torque:

   Stage 1: 44 lb.in (5 Nm)

   Stage 2: 18 lb.ft (25 Nm)

   Stage 3: 18 lb.ft (25 Nm)

Torque: 177 lb.in (20 Nm)

1. 1.
   
   Install the turbocharger inlet tube retainers.

• Install the turbocharger inlet tube and tighten the clamp.

• Connect the vent hose.