Block Heater: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
Inspect the sealing surfaces and clean with metal surface prep wipes.Material: Motorcraft ® Metal Surface Prep / ZC-31-A
- 2.
Position the block heater and finger-tighten the nut, making sure the block heater electrical connector points to the 9 o'clock position.
- 4.NOTE: Route the block heater power cable away from hot or rotating components, or the cable can be damaged.
Connect the electrical connector.
- 5.
Install the catalytic converter. Refer to: Catalytic Converter .
- 6.
Fill and bleed the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .