Pinpoint Test B : Unusual Starter Noise
WARNING: This page is about a different variant/trim than selected.
- B1 CHECK THE STARTER MOUNTING
- Inspect the starter mounting bolts for looseness.
Is the starter motor mounted correctly?
Yes GO to B2 No INSTALL the starter motor correctly. Refer to: Starter Motor . - B2 CHECK FOR ENGINE NOISE
- Ignition OFF.
- Connect a remote starter switch between the starter solenoid C197A-1 ("B" terminal) and C197B-1 ("B" terminal).
- Engage the starter and verify the noise is due to starter operation.
Is the noise due to the starter engagement?
Yes REFER to: Starter Motor Drive Gear and Flywheel Ring Gear Inspection . No REFER to: Engine to continue diagnosis.