Brake Vacuum Pump - 1.0L EcoBoost (90kW/120PS): Removal

NOTE: Removal steps in this procedure may contain installation details.

1.

Remove the engine appearance cover.

GFD138508

Courtesy of FORD MOTOR COMPANY

2.

Squeeze the sides of the coupling and disconnect the vacuum tube.

GFD138509

Courtesy of FORD MOTOR COMPANY

3.

Detach the wiring retainer.

GFD138510

Courtesy of FORD MOTOR COMPANY

4.
- NOTE: Use care when disconnecting the vacuum hose from the vacuum pump or damage to the valve may occur. If the valve is broken and a new pump is not being installed, the valve can be replaced sparately.
  
  Release the clamp and disconnect the vacuum hose.
- Detach the wiring and vacuum hose retainers.
- Remove the nuts and position the vacuum control regulator aside.
  Torque: 89 lb.in (10 Nm)

GFD138511

Courtesy of FORD MOTOR COMPANY

5.

NOTE: Manually align the brake vacuum pump drive key with the camshaft slot before installation.
- 1.
  
  Remove the bolts and the brake vacuum pump. Discard the bolts.
  Torque: 89 lb.in (10 Nm)
- 2.
  
  Remove and discard the gasket.

GFD138512

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Make sure the mating surfaces are clean and free of foreign material and thread lock residue is cleaned from the bolt holes.

Clean the mating surfaces and tap the bolt holes.

Material: Motorcraft ® Metal Surface Prep Wipes / ZC-31-B

GFD138513

Courtesy of FORD MOTOR COMPANY