Ignition Coil-On-Plug: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Inspect and replace any ignition coil-on-plugs that have rubber boots with cracks, rips or tears.

GFD139908

Courtesy of FORD MOTOR COMPANY

2.

NOTE: Install the ignition coil-on-plug bolts finger tight at this stage.
- 1.
  
  Install the ignition coil-on-plugs.
- 2.
  
  Install and tighten the ignition coil-on-plug bolts.
  Torque: 89 lb.in (10 Nm)
- 3.
  
  Push the wire harness side connector onto the ignition coil-on-plug connector until locked. A clicking sound will be heard when fully seated. Slide the red locking tab (CPA) toward the ignition coil-on-plug until a second clicking sound is heard.

GFD139909

Courtesy of FORD MOTOR COMPANY