Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.

1.

To install, reverse the removal procedure.

2.

NOTE: The step is only necessary when installing a new component.

Using a diagnostic scan tool, complete the PMI process for the PCM following the on-screen instructions.

3.

NOTE: The step is only necessary when installing a new component.
- Carry out the Parameter Reset procedure.
- Vehicles without keyless entry and push button start.Refer to: Passive Anti-Theft System (PATS) Parameter Reset .
- Vehicles with keyless entry and push button start.Refer to: Passive Anti-Theft System (PATS) Parameter Reset .
- After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.