LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Fiesta Titanium, 4D Hatchback, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Cooling System - 1.6L ECOBOOST (132KW/180PS) - Sigma) >> Removal And Installation >> Block Heater >> Removal

Block Heater: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .

  1. 2.

    Remove the catalytic converter. Refer to: Catalytic Converter .

  1. 3.

    NOTE: Make sure the block heater wiring is routed and secured away from rotating or hot components.

    Disconnect the block heater electrical connector.

GFD139748Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove the block heater locking nut and the block heater.
GFD139749Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals