Pinpoint Test A : Engine Does Not Crank: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Starting System for schematic and connector information.
Refer to Turn Signal/Stop/Hazard Lamps for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Starting System - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06E9 | Engine Starter Performance | Sets when no engine rotation is detected during crank event. |
| P0830 | Clutch Pedal "A" Circuit | Sets when the PCM receives vehicle speed input, indicating vehicle movement and does not detect the switching input from the clutch pedal position switch. |
Possible Sources
- Battery
- Battery cables
- Starter motor
- BJB starter relay
Visual Inspection and Diagnostic Pre-checks
- Inspect high current BJB connections.
- Verify the BJB fuse 10 (30A).
- Verify the High Current BJB MEGA 1 fuse (450A).
- Inspect the CPP switch.
- Inspect the Passive Key.